Machines made by Lam Automation
Bushing insertion machine
With this insertion machine you can insert the necessary components into the plastic parts you want.
​
This station which requires 1 operator can have various plastic models, it can have interchangeable cradles / fixtures.
​
These machines are mainly purchased by plastic injection companies for the automotive industry.
Do you want a machine that helps speed up your production processes?
​
Do not hesitate to contact us: lam@lamautomation.com
Continuity testing and measurement indexing machine.
The objective of this machine is to carry out continuity and measurement tests on all of our client's plastic parts, each piece contains copper pins inserted inside.
​
Likewise, this machine, having several sensors, would detect those parts that meet the requirement.
Those that did not meet the requirement would be automatically thrown into the scrab area.
Do you want a machine that helps speed up your production processes?
​
Do not hesitate to contact us: lam@lamautomation.com
Pin cutting and bending machine.
This automated machine was designed and built in order to perform the cutting and bending of each copper pin that comes in a connected strip of copper in series of pins.
​
The machine has a close tolerance die which allows us to meet the tolerances requested by our client of up to .08 mm.
​
Once the pin is bent and cut, it is placed in a fixture so that the operator with a manual gripper can grab those pins.
Do you want a machine that helps speed up your production processes?
​
Do not hesitate to contact us: lam@lamautomation.com
Assembly machine, leak test and marking
This 3-in-1 machine allowed our client to accelerate their production processes by carrying out 3 processes in a single machine.
​
2 operators were required for this machine in order to optimize times.
​
If the plastic part does not meet the leak test parameters, it is thrown into the SCRAB box that contains the same machine.
Do you want a machine that helps speed up your production processes?
​
Do not hesitate to contact us: lam@lamautomation.com
Assembly machine
This assembly machine has a fixture in the center for placing a plastic pipe to which several components had to be assembled.
​
For this assembly machine, 1 operator was required.
​
The machine has sensors to detect that all the components are in position to be assembled, otherwise the machine would not start the assembly cycle until all the components were in their correct position.
Do you want a machine that helps speed up your production processes?
​
Do not hesitate to contact us: lam@lamautomation.com
Automatic screw driving machine.
The objective of this automated machine is to screw precisely in the previously programmed location, in this case where the operator placed some screws and also screw at the torque requested by our client.
​
The screwed piece was an antenna for a pick-up vehicle company.
​
The automatic screwdriver made it possible to drastically reduce manual screwdriving times and the scrab previously generated by operators when screwing at a torque greater than the established one.
Do you want a machine that helps speed up your production processes?
​
Do not hesitate to contact us: lam@lamautomation.com